My O2+:
Code:
# /usr/bin/hinv -vm
CPU: MIPS R12000 Processor Chip Revision: 3.5
FPU: MIPS R12010 Floating Point Chip Revision: 0.0
1 400 MHZ IP32 Processor
Main memory size: 1024 Mbytes
Secondary unified instruction/data cache size: 2 Mbytes on Processor 0
Instruction cache size: 32 Kbytes
Data cache size: 32 Kbytes
FLASH PROM version 4.18
Integral SCSI controller 0: Version ADAPTEC 7880
Disk drive: unit 2 on SCSI controller 0 (unit 2)
CDROM: unit 4 on SCSI controller 0
Integral SCSI controller 1: Version ADAPTEC 7880
On-board serial ports: tty1
On-board serial ports: tty2
On-board EPP/ECP parallel port
CRM graphics installed
Integral Ethernet: ec0, version 1
Iris Audio Processor: version A3 revision 0
PCI Adapter ID (vendor 0x9004, device 0x8078) PCI slot 1
PCI Adapter ID (vendor 0x9004, device 0x8078) PCI slot 2
PCI Adapter ID (vendor 0x1412, device 0x1724) PCI slot 3
Video: MVP unit 0 version 1.4
AV: AV1 Card version 1, Camera not connected.
Vice: TRE
Code:
# /usr/gfx/gfxinfo -vv
Graphics board 0 is "CRM" graphics.
Managed (":0.0") 1280x1024
32 + 32 bitplanes
board revision 2, CRM revision C, GBE revision B
Monitor 0 type: ACR 569
Channel 0:
Origin = (0,0)
Video Output: 1280 pixels, 1024 lines, 75.03Hz (1280x1024_75)
Video Format Flags: (none)
Sync Disabled
Using Gamma Map 0
Monitor Type: ACR-569
Code:
# /usr/sbin/scsicontrol -i /dev/scsi/*
/dev/scsi/sc0d2l0: Disk COMPAQ BD0726459C B008
ANSI vers 2, ISO ver: 0, ECMA ver: 0; supports: 16bit synch linkedcmds cmdqueing
Device is ready
/dev/scsi/sc0d4l0: CD-ROM TOSHIBA DVD-ROM SD-M14011F09
ANSI vers 2, ISO ver: 0, ECMA ver: 0; supports: synch linkedcmds
Device is not ready
Here are some photos:
Attachment:
o2+-c2.jpg [ 253.22 KiB | Viewed 137 times ]
Attachment:
o2+-c3.jpg [ 367.06 KiB | Viewed 137 times ]