SGI: hinv

Fuel V10 R14000 600 MHz 2GB

I thought I'd show you what I found in the mail yesterday. One of the lower Fuel configurations, but it is in very good shape. I'll post pictures later on.

Code:
1 600 MHZ IP35 Processor
CPU: MIPS R14000 Processor Chip Revision: 2.3
FPU: MIPS R14010 Floating Point Chip Revision: 2.3
Main memory size: 2048 Mbytes
Instruction cache size: 32 Kbytes
Data cache size: 32 Kbytes
Secondary unified instruction/data cache size: 4 Mbytes
Integral SCSI controller 0: Version QL12160, low voltage differential
Disk drive: unit 1 on SCSI controller 0
Integral SCSI controller 1: Version QL12160, single ended
CDROM: unit 4 on SCSI controller 1
IOC3 serial port: tty1
IOC3 serial port: tty2
IOC3 parallel port: plp1
Graphics board: V10
Integral Fast Ethernet: ef0, version 1, module 001c01, pci 4
USB controller: type OHCI


Long version:

Code:
Location: /hw/module/001c01/node
IP34 Board: barcode MPH415     part 030-1707-003 rev -H
Location: /hw/module/001c01/Ibrick/xtalk/13
ASTODYB Board: barcode MRR195     part 030-1725-001 rev -F
Location: /hw/module/001c01/Ibrick/xtalk/14
IP34 Board: barcode MPH415     part 030-1707-003 rev -H
Location: /hw/module/001c01/Ibrick/xtalk/15
IP34 Board: barcode MPH415     part 030-1707-003 rev -H
1 600 MHZ IP35 Processor
CPU: MIPS R14000 Processor Chip Revision: 2.3
FPU: MIPS R14010 Floating Point Chip Revision: 2.3
CPU 0 at Module 001c01/Slot 0/Slice A: 600 Mhz MIPS R14000 Processor Chip (enabled)
Processor revision: 2.3. Scache: Size 4 MB Speed 300 Mhz  Tap 0xa
Main memory size: 2048 Mbytes
Instruction cache size: 32 Kbytes
Data cache size: 32 Kbytes
Secondary unified instruction/data cache size: 4 Mbytes
Memory at Module 001c01/Slot 0: 2048 MB (enabled)
Bank 0 contains 512 MB (Standard) DIMMS (enabled)
Bank 1 contains 512 MB (Standard) DIMMS (enabled)
Bank 2 contains 512 MB (Standard) DIMMS (enabled)
Bank 3 contains 512 MB (Standard) DIMMS (enabled)
Integral SCSI controller 0: Version QL12160, low voltage differential
Disk drive: unit 1 on SCSI controller 0 (unit 1)
Integral SCSI controller 1: Version QL12160, single ended
CDROM: unit 4 on SCSI controller 1
IOC3 serial port: tty1
IOC3 serial port: tty2
IOC3 parallel port: plp1
Graphics board: V10
Integral Fast Ethernet: ef0, version 1, module 001c01, pci 4
PCI Adapter ID (vendor 4215, device 4630) pci slot 1
PCI Adapter ID (vendor 4265, device 3) pci slot 4
PCI Adapter ID (vendor 4545, device 22530) pci slot 5
HUB in Module 001c01/Slot 0: Revision 2 Speed 200.00 Mhz (enabled)
IP35prom in Module 001c01/Slot n0: Revision 6.135
USB controller: type OHCI


gfxinfo:

Code:
Graphics board 0 is "ODYSSEY" graphics.
Managed (":0.0") 1280x1024
BUZZ version B.1
PB&J version 1
32MB memory
Banks: 2, CAS latency: 3
Monitor 0 type: SAM 1126

_________________
www.sgistuff.net - SGI info since 2001

:4D70G: :PI: :PI: :PI: :PI: :PI: :PI: :4D220VGX: :4D220VGX: :PWRSeries: :Crimson: :Crimson: :Indigo: :Indigo: :Indigo: :Indy: :Indy: :Indy: :Indy: :Indy: :Indy: :Indigo2: :Indigo2: :Indigo2: :Indigo2: :Indigo2: :Indigo2IMP: :Indigo2IMP: :Onyx: :ChallengeL: :O2: :O2: :Octane: :Octane: :Octane: :Onyx2: :Fuel:
very nice, the classic, 600/v10 :D

_________________
r-a-c.de
Indeed. There was a bunch of better equipped batch of Fuels on the bay a few months ago.

At least this one is clean and almost looks unused (can't say that for most of my other systems):

Attachment:
DSC_7675.jpg
DSC_7675.jpg [ 170.33 KiB | Viewed 120 times ]

_________________
www.sgistuff.net - SGI info since 2001

:4D70G: :PI: :PI: :PI: :PI: :PI: :PI: :4D220VGX: :4D220VGX: :PWRSeries: :Crimson: :Crimson: :Indigo: :Indigo: :Indigo: :Indy: :Indy: :Indy: :Indy: :Indy: :Indy: :Indigo2: :Indigo2: :Indigo2: :Indigo2: :Indigo2: :Indigo2IMP: :Indigo2IMP: :Onyx: :ChallengeL: :O2: :O2: :Octane: :Octane: :Octane: :Onyx2: :Fuel:
Very Nice!

_________________
:Octane2: :Octane2: :Octane: :O2: :Indigo2IMP: :Indigo2:

Octane2 2x600 V12 8GB
- Octane2 600 V12 2GB - Octane 2x400 V10 2GB
O2 350 CRM 256MB - Indigo² 195 Max Impact 386MB - Indigo² 250 Extreme 386MB

"I'm totally unappreciated in my time. You can run this whole park from this room, with minimal staff, for up to three days. You think that kind of automation is easy? Or cheap? You know anybody who can network eight Connection Machines and de-bug two million lines of code for what I bid this job? Because if you can, I'd love to see him try."
Looks very clean! I wouldn't worry about the V10, I've got one at work and it works fine even @ 1920x1200

_________________
Now this is a deep dark secret, so everybody keep it quiet :)
It turns out that when reset, the WD33C93 defaults to a SCSI ID of 0, and it was simpler to leave it that way... -- Dave Olson, in comp.sys.sgi

Currently in commercial service: Image :Octane2: :Onyx2: (2x) :0300:
In the museum: almost every MIPS/IRIX system.
Wow, that's one clean Fuel! Nice!

_________________
:Onyx2: :Octane2: :Indigo2: :0300:
Onyx2, 4x400 MHz, IR3 // Origin 300, 4x600MHz
Octane2, 2x400 MHz, V12 // Indigo2, 200 MHz, Extreme
indeed, excellent condition

_________________
r-a-c.de