The collected works of svizi

I am ressurecting the thread as i got my hands into a 3com 996B.
Is there somewhere a dump i can use to flash my card?

I have done the procedures described above and at first the card seemed to worked as expected.
Today though after changing some network settings i got a pci bridge alert and some assorted messages that were followed by a reboot.
From then on i cannot boot the machine with the card inside the pci cage.
Any thoughts?
Can i somehow figure out that the pci card cage is working without any compatible pci card laying around?

I booted the machine checking the console through a serial connection and i get the following

XIO Slot Reset Failure *FAILED*

Check or replace: XIO device 11

Any thoughts?

A modern version of Inkscape would be nice.
From a quick search at the compiling instructions and nekoware it seems that the requirements are here...

Doing a further search on Inkscape 0.45 Release Notes i found the below:

Thanks to patches submitted by users of our community, Inkscape can now be built on SGI IRIX 6.5.28, gcc 3.4.0 systems and on Tru64 systems.

Anyone can help on this. Is there a binary around?

From the classics a Power Macintosh MDD Dual 867Mhz with 2GB RAM.
Also an iPad Mini 2 with Retina Display.

I can test on Archlinux and Fedora 23.

Nice looking system!