Nekonomicon - Indigo, R4400 150MHz, 128MB, Elan

snowolf
Journeyman
Who joined Sept. 25, 2009, 10:15 p.m.
and authored 32 notes

Wrote the following at May 10, 2010, 10:09 p.m...

I finally gave this puppy a proper name. I'm planning to max out the memory but 6.5.22m seems to run decent even on 128MB. If there's any interest, I'll look into taking some pictures of it.

Code:

  shodan 1# hinv -mv
  
  CPU: MIPS R4400 Processor Chip Revision: 5.0
  
  FPU: MIPS R4000 Floating Point Coprocessor Revision: 0.0
  
  1 150 MHZ IP20 Processor
  
  Main memory size: 128 Mbytes
  
  Secondary unified instruction/data cache size: 1 Mbyte on Processor 0
  
  Instruction cache size: 16 Kbytes
  
  Data cache size: 16 Kbytes
  
  Integral SCSI controller 0: Version WD33C93B, revision C
  
  Disk drive: unit 1 on SCSI controller 0 (unit 1)
  
  On-board serial ports: 2
  
  On-board bi-directional parallel port
  
  Graphics board: GR2-Elan
  
  Integral Ethernet: ec0, version 1
  
  Iris Audio Processor: revision 10

Code:

  shodan 2# /usr/gfx/gfxinfo
  
  Graphics board 0 is "GR2" graphics.
  
  Managed (":0.0") 1280x1024
  
  4 GEs, 1 RE, 24 bitplanes, 4 auxplanes, 4 cidplanes, Z-buffer
  
  GR2 revision 2, VB1.1
  
  HQ2 rev A, GE7 rev B,  RE3 rev D, VC1 rev B, MC rev C
  
  19" monitor

Code:

  shodan 3# uname -a
  
  IRIX IRIS 6.5 10070055 IP20
  
  shodan 4# cc -version
  
  MIPSpro Compilers: Version 7.4.4m

_________________
:Indigo:

jan-jaap
Old Salt
Who joined June 17, 2004, 11:35 a.m.
and authored 2688 notes

Wrote the following at May 11, 2010, 12:41 a.m...

Nice classic

snowolf wrote:

I'm planning to max out the memory

Since you ave a rev. "C" MC chip, you can. Otherwise it would start to complain when you install more than 256MB.

_________________
Now this is a deep dark secret, so everybody keep it quiet

It turns out that when reset, the WD33C93 defaults to a SCSI ID of 0, and it was simpler to leave it that way... -- Dave Olson, in comp.sys.sgi
Currently in commercial service: