Code: Select all
Location: /hw/module/001c01/node
IP34 Board: barcode NEG105 part 030-1707-004 rev -C
Location: /hw/module/001c01/node/cpubus/0
IP34PIMM Board: barcode NCL713 part 030-1891-001 rev -D
Location: /hw/module/001c01/Ibrick/xtalk/13
ASTODY Board: barcode NCL553 part 030-1726-005 rev -A
Location: /hw/module/001c01/Ibrick/xtalk/14
IP34 Board: barcode NEG105 part 030-1707-004 rev -C
Location: /hw/module/001c01/Ibrick/xtalk/15
IP34 Board: barcode NEG105 part 030-1707-004 rev -C
1 700 MHZ IP35 Processor
CPU: MIPS R16000 Processor Chip Revision: 2.1
FPU: MIPS R16010 Floating Point Chip Revision: 2.1
CPU 0 at Module 001c01/Slot 0/Slice A: 700 Mhz MIPS R16000 Processor Chip (enabled)
Processor revision: 2.1. Scache: Size 4 MB Speed 350 Mhz Tap 0xa
Main memory size: 2048 Mbytes
Instruction cache size: 32 Kbytes
Data cache size: 32 Kbytes
Secondary unified instruction/data cache size: 4 Mbytes
Memory at Module 001c01/Slot 0: 2048 MB (enabled)
Bank 0 contains 512 MB (Standard) DIMMS (enabled)
Bank 1 contains 512 MB (Standard) DIMMS (enabled)
Bank 2 contains 512 MB (Standard) DIMMS (enabled)
Bank 3 contains 512 MB (Standard) DIMMS (enabled)
Integral SCSI controller 2: Version Fibre Channel QL2200A, 66 MHz PCI
Integral SCSI controller 3: Version Fibre Channel QL2200A, 66 MHz PCI
Integral SCSI controller 0: Version QL12160, low voltage differential
Disk drive: unit 1 on SCSI controller 0 (unit 1)
Integral SCSI controller 1: Version QL12160, single ended
CDROM: unit 6 on SCSI controller 1
IOC3/IOC4 serial port: tty1
IOC3/IOC4 serial port: tty2
IOC3 parallel port: plp1
Graphics board: V12
Gigabit Ethernet: eg0, module 001c01, pci_bus 1, pci_slot 2, firmware version 12.4.10
Integral Fast Ethernet: ef0, version 1, module 001c01, pci 4
Iris Audio Processor: version MAD revision 1, number 1
PCI Adapter ID (vendor 0x1077, device 0x2200) PCI slot 1
PCI Adapter ID (vendor 0x1077, device 0x2200) PCI slot 2
PCI Adapter ID (vendor 0x1077, device 0x1216) PCI slot 1
PCI Adapter ID (vendor 0x10a9, device 0x0009) PCI slot 2
PCI Adapter ID (vendor 0x1412, device 0x1724) PCI slot 3
PCI Adapter ID (vendor 0x10a9, device 0x0003) PCI slot 4
PCI Adapter ID (vendor 0x1045, device 0xc861) PCI slot 5
HUB in Module 001c01/Slot 0: Revision 2 Speed 200.00 Mhz (enabled)
IP35prom in Module 001c01/Slot n0: Revision 6.210
USB controller: type OHCI
Code: Select all
Graphics board 0 is "ODYSSEY" graphics.
Managed (":0.0") 1600x1200
BUZZ version B.2
PB&J version 1
128MB memory
Banks: 4, CAS latency: 3
Monitor 0 type: SAM 430
Channel 0:
Origin = (0,0)
Video Output: 1600 pixels, 1200 lines, 59.83Hz (1600x1200_60)