The collected works of gamma

Well, this got out of hand quickly. I was in the market for a PCI shoebox and gigE for my Octane2 and wound up buying two 0300 nodes and a numalink cable. There goes the power bill. :D

Code:
[CRONUS]:~ $ hinv -vm
Location: /hw/module/001c01/node
IP45_4CPU Board: barcode MRH757     part 030-1797-001 rev -B
Location: /hw/module/001c01/Ibrick/xtalk/14
IO8 Board: barcode MRD373     part 030-1673-004 rev -C
Location: /hw/module/001c01/Ibrick/xtalk/15
IO8 Board: barcode MRD373     part 030-1673-004 rev -C
Location: /hw/module/001c02/node
IP45_4CPU Board: barcode MNS918     part 030-1797-001 rev -B
Location: /hw/module/001c02/Ibrick/xtalk/14
IO8 Board: barcode MNS999     part 030-1673-003 rev -G
Location: /hw/module/001c02/Ibrick/xtalk/15
IO8 Board: barcode MNS999     part 030-1673-003 rev -G
8 600 MHZ IP35 Processors
CPU: MIPS R14000 Processor Chip Revision: 2.4
FPU: MIPS R14010 Floating Point Chip Revision: 2.4
CPU 0 at Module 001c01/Slot 0/Slice A: 600 Mhz MIPS R14000 Processor Chip (enabled)
Processor revision: 2.4. Scache: Size 4 MB Speed 300 Mhz  Tap 0xa
CPU 1 at Module 001c01/Slot 0/Slice B: 600 Mhz MIPS R14000 Processor Chip (enabled)
Processor revision: 2.4. Scache: Size 4 MB Speed 300 Mhz  Tap 0xa
CPU 2 at Module 001c01/Slot 0/Slice C: 600 Mhz MIPS R14000 Processor Chip (enabled)
Processor revision: 2.4. Scache: Size 4 MB Speed 300 Mhz  Tap 0xa
CPU 3 at Module 001c01/Slot 0/Slice D: 600 Mhz MIPS R14000 Processor Chip (enabled)
Processor revision: 2.4. Scache: Size 4 MB Speed 300 Mhz  Tap 0xa
CPU 4 at Module 001c02/Slot 0/Slice A: 600 Mhz MIPS R14000 Processor Chip (enabled)
Processor revision: 2.4. Scache: Size 4 MB Speed 300 Mhz  Tap 0xa
CPU 5 at Module 001c02/Slot 0/Slice B: 600 Mhz MIPS R14000 Processor Chip (enabled)
Processor revision: 2.4. Scache: Size 4 MB Speed 300 Mhz  Tap 0xa
CPU 6 at Module 001c02/Slot 0/Slice C: 600 Mhz MIPS R14000 Processor Chip (enabled)
Processor revision: 2.4. Scache: Size 4 MB Speed 300 Mhz  Tap 0xa
CPU 7 at Module 001c02/Slot 0/Slice D: 600 Mhz MIPS R14000 Processor Chip (enabled)
Processor revision: 2.4. Scache: Size 4 MB Speed 300 Mhz  Tap 0xa
Main memory size: 7168 Mbytes
Instruction cache size: 32 Kbytes
Data cache size: 32 Kbytes
Secondary unified instruction/data cache size: 4 Mbytes
Memory at Module 001c01/Slot 0: 4096 MB (enabled)
Bank 0 contains 1024 MB (Premium) DIMMS (enabled)
Bank 1 contains 1024 MB (Premium) DIMMS (enabled)
Bank 2 contains 1024 MB (Premium) DIMMS (enabled)
Bank 3 contains 1024 MB (Premium) DIMMS (enabled)
Memory at Module 001c02/Slot 0: 3072 MB (enabled)
Bank 0 contains 512 MB (Standard) DIMMS (enabled)
Bank 1 contains 512 MB (Standard) DIMMS (enabled)
Bank 2 contains 1024 MB (Premium) DIMMS (enabled)
Bank 3 contains 1024 MB (Premium) DIMMS (enabled)
Integral SCSI controller 6: Version QL12160, low voltage differential
Integral SCSI controller 7: Version QL12160, low voltage differential
Integral SCSI controller 0: Version QL12160, low voltage differential
Disk drive: unit 1 on SCSI controller 0 (unit 1) (XVM Local Disk) (primary path)
Integral SCSI controller 1: Version QL12160, low voltage differential
IOC3/IOC4 serial port: tty7
IOC3/IOC4 serial port: tty8
IOC3/IOC4 serial port: tty5
IOC3/IOC4 serial port: tty6
Gigabit Ethernet: eg1, module 001c02, pci_bus 2, pci_slot 2, firmware version 0.0.0
Gigabit Ethernet: eg0, module 001c01, pci_bus 2, pci_slot 2, firmware version 12.4.10
Fast Ethernet: ef1, version 1, module 001c02, pci 4
Integral Fast Ethernet: ef0, version 1, module 001c01, pci 4
PCI Adapter ID (vendor 0x10a9, device 0x0009) PCI slot 2
PCI Adapter ID (vendor 0x10a9, device 0x0009) PCI slot 2
PCI Adapter ID (vendor 0x1077, device 0x1216) PCI slot 1
PCI Adapter ID (vendor 0x10a9, device 0x0003) PCI slot 4
PCI Adapter ID (vendor 0x11c1, device 0x5802) PCI slot 5
PCI Adapter ID (vendor 0x1077, device 0x1216) PCI slot 1
PCI Adapter ID (vendor 0x10a9, device 0x0003) PCI slot 4
PCI Adapter ID (vendor 0x11c1, device 0x5802) PCI slot 5
IOC3/IOC4 external interrupts: 2
IOC3/IOC4 external interrupts: 1
HUB in Module 001c01/Slot 0: Revision 2 Speed 200.00 Mhz (enabled)
HUB in Module 001c02/Slot 0: Revision 2 Speed 200.00 Mhz (enabled)
IP35prom in Module 001c01/Slot n0: Revision 6.210
IP35prom in Module 001c02/Slot n0: Revision 6.210
USB controller: type OHCI
USB controller: type OHCI