Nekonomicon - FS/T: 600MHz Fuel, V10, 3GB, 36 and 300GB HDs, DDS4

recondas
Moderator
Who joined June 6, 2004, 4:55 p.m.
and authored 4835 notes

Wrote the following at Nov. 12, 2012, 9:10 a.m...

For Sale (or possibly trade): 600Mhz Fuel 1GB, V10 graphics, 3GB of memory (two 1GB and two 512MB DIMMs), has both a 36GB and 300GB hard drive, an internal DVD-ROM drive, EMU audio, and an internal DDS4 tape drive. If desired, I also have an SGI F180 18" LCD monitor that could be purchased separately (though you should be able use just about any standard monitor with a DVI port - because of its DVI graphics port, the Fuel does not require a sync-on-green monitor).

I'm located in central North Carolina USA.

This one has a later revision motherboard (that isn't prone to the faulty environmental monitoring chip), and a late revision 460 watt power supply (not know to be as failure prone as the earlier revision 430w NMB units).

The Fuel includes a clean install of a hardware appropriate operating system (PM me for details). If desired I can do initial configuration for the buyer (networking, user account, etc.)

The skins look pretty good, but they aren't perfect - it's the one on the left in the attached photo:

Attachment:

DSCN9239.JPG [ 89.51 KiB | Viewed 1179 times ]

Code:

  hinv -vm
  
  Location: /hw/module/001c01/node
  
  IP34 Board: barcode NCL381     part 030-1707-004 rev -A
  
  Location: /hw/module/001c01/node/cpubus/0
  
  IP34PIMM Board: barcode NCL234     part 030-1730-002 rev -E
  
  Location: /hw/module/001c01/Ibrick/xtalk/13
  
  ASTODYV10 Board: barcode NAT111     part 030-1826-001 rev -B
  
  Location: /hw/module/001c01/Ibrick/xtalk/14
  
  IP34 Board: barcode NCL381     part 030-1707-004 rev -A
  
  Location: /hw/module/001c01/Ibrick/xtalk/15
  
  IP34 Board: barcode NCL381     part 030-1707-004 rev -A
  
  1 600 MHZ IP35 Processor
  
  CPU: MIPS R14000 Processor Chip Revision: 2.4
  
  FPU: MIPS R14010 Floating Point Chip Revision: 2.4
  
  CPU 0 at Module 001c01/Slot 0/Slice A: 600 Mhz MIPS R14000 Processor Chip (enabled)
  
  Processor revision: 2.4. Scache: Size 4 MB Speed 300 Mhz  Tap 0xa
  
  Main memory size: 3072 Mbytes
  
  Instruction cache size: 32 Kbytes
  
  Data cache size: 32 Kbytes
  
  Secondary unified instruction/data cache size: 4 Mbytes
  
  Memory at Module 001c01/Slot 0: 1536 MB (enabled)
  
  Bank 0 contains 512 MB (Standard) DIMMS (enabled)
  
  Bank 1 contains 512 MB (Standard) DIMMS (enabled)
  
  Bank 2 contains 1024 MB (Premium) DIMMS (enabled)
  
  Bank 3 contains 1024 MB (Premium) DIMMS (enabled)
  
  Integral SCSI controller 0: Version QL12160, low voltage differential
  
  Disk drive: unit 1 on SCSI controller 0 (unit 1)
  
  Disk drive: unit 3 on SCSI controller 0 (unit 3)
  
  Tape drive: unit 6 on SCSI controller 0: DAT
  
  Integral SCSI controller 1: Version QL12160, single ended
  
  CDROM: unit 6 on SCSI controller 1
  
  IOC3/IOC4 serial port: tty1
  
  IOC3/IOC4 serial port: tty2
  
  IOC3 parallel port: plp1
  
  Graphics board: V10
  
  Gigabit Ethernet: eg0, module 001c01, pci_bus 2, pci_slot 2, firmware version 0.0.0
  
  Integral Fast Ethernet: ef0, version 1, module 001c01, pci 4
  
  Iris Audio Processor: version EMU revision A3, number 1
  
  PCI Adapter ID (vendor 0x10a9, device 0x0009) PCI slot 2
  
  PCI Adapter ID (vendor 0x1077, device 0x1216) PCI slot 1
  
  PCI Adapter ID (vendor 0x1102, device 0x0004) PCI slot 3
  
  PCI Adapter ID (vendor 0x1102, device 0x7003) PCI slot 3
  
  PCI Adapter ID (vendor 0x1102, device 0x4001) PCI slot 3
  
  PCI Adapter ID (vendor 0x10a9, device 0x0003) PCI slot 4
  
  PCI Adapter ID (vendor 0x1045, device 0xc861) PCI slot 5
  
  HUB in Module 001c01/Slot 0: Revision 2 Speed 200.00 Mhz (enabled)
  
  IP35prom in Module 001c01/Slot n0: Revision 6.210
  
  USB controller: type OHCI
  
  USB Human Interface Device: device id 0 type mouse
  
  USB Human Interface Device: device id 0 type keyboard

Code:

  l1cmd serial all
  
  Data                            Location      Value
  
  ------------------------------  ------------  --------
  
  Local System Serial Number      EEPROM        08:00:69:10:72:F2
  
  Local Brick Serial Number       EEPROM        NCL381
  
  Reference Brick Serial Number   NVRAM         NCL381
  
  EEPROM      Product Name    Serial         Part Number           Rev  T/W
  
  ----------  --------------  -------------  --------------------  ---  ------
  
  NODE        IP34            NCL381         030_1707_004          A    00
  
  MAC         MAC ADDRESS     NA             NA                    NA   NA
  
  PIMM        IP34PIMM        NCL234         030_1730_002          E    00
  
  XIO         ASTODYV10       NAT111         030_1826_001          B    00
  
  EEPROM     JEDEC-SPD Info           Part Number        Rev  Speed  SGI
  
  ---------- ------------------------ ------------------ ---- ------ --------
  
  DIMM 0     CE000000000000000C44CD02 M3 46L3313ET3-CA0   3E    10.0  N/A
  
  DIMM 2     CE000000000000000C3B0000 M3 47L6423DT2-CA0   3E    10.0  N/A
  
  DIMM 1     CE000000000000000C39CD02 M3 46L3313ET3-CA0   3E    10.0  N/A
  
  DIMM 3     CE000000000000000C730100 M3 47L6423DT2-CA0   3E    10.0  N/A

Code:

  l1cmd env
  
  Environmental monitoring is enabled and running.
  
  Description    State       Warning Limits     Fault Limits       Current
  
  -------------- ----------  -----------------  -----------------  -------
  
  12V    Enabled  10%  10.80/ 13.20  20%   9.60/ 14.40   12.19
  
  12V IO    Enabled  10%  10.80/ 13.20  20%   9.60/ 14.40   12.19
  
  5V    Enabled  10%   4.50/  5.50  20%   4.00/  6.00    5.02
  
  3.3V    Enabled  10%   2.97/  3.63  20%   2.64/  3.96    3.32
  
  2.5V    Enabled  10%   2.25/  2.75  20%   2.00/  3.00    2.47
  
  1.5V    Enabled  10%   1.35/  1.65  20%   1.20/  1.80    1.47
  
  5V aux    Enabled  10%   4.50/  5.50  20%   4.00/  6.00    5.10
  
  3.3V aux    Enabled  10%   2.97/  3.63  20%   2.64/  3.96    3.27
  
  PIMM0 12V bias    Enabled  10%  10.80/ 13.20  20%   9.60/ 14.40   12.19
  
  Fuel SRAM    Enabled  10%   2.25/  2.75  20%   2.00/  3.00    2.52
  
  Fuel CPU    Enabled  10%   1.44/  1.76  20%   1.28/  1.92    1.59
  
  PIMM0 1.5V    Enabled  10%   1.35/  1.65  20%   1.20/  1.80    1.48
  
  PIMM0 3.3V aux    Enabled  10%   2.97/  3.63  20%   2.64/  3.96    3.27
  
  PIMM0 5V aux    Enabled  10%   4.50/  5.50  20%   4.00/  6.00    5.07
  
  XIO 12V bias    Enabled  10%  10.80/ 13.20  20%   9.60/ 14.40   12.06
  
  XIO 5V    Enabled  10%   4.50/  5.50  20%   4.00/  6.00    5.02
  
  XIO 2.5V    Enabled  10%   2.25/  2.75  20%   2.00/  3.00    2.46
  
  XIO 3.3V aux    Enabled  10%   2.97/  3.63  20%   2.64/  3.96    3.30
  
  Description    State       Warning RPM  Current RPM
  
  -------------- ----------  -----------  -----------
  
  FAN 0  EXHAUST    Enabled          920         1155
  
  FAN 1       HD    Enabled         1560         2250
  
  FAN 2      PCI    Enabled         1120         1591
  
  FAN 3    XIO 1    Enabled         1600         2596
  
  FAN 4    XIO 2    Enabled         1600         2481
  
  FAN 5       PS    Enabled         1349         3183
  
  Advisory   Critical   Fault      Current
  
  Description       State       Temp       Temp       Temp       Temp
  
  ----------------- ----------  ---------  ---------  ---------  ---------
  
  0 NODE 0            Enabled    [Autofan Control]    75C/167F   44C/111F
  
  1 NODE 1            Enabled    [Autofan Control]    75C/167F   44C/111F
  
  2 NODE 2            Enabled    [Autofan Control]    75C/167F   35C/ 95F
  
  3 PIMM              Enabled    [Autofan Control]    75C/167F   53C/127F
  
  4 ODYSSEY           Enabled    [Autofan Control]    75C/167F   44C/111F
  
  5 BEDROCK           Enabled    [Autofan Control]    85C/185F   46C/114F

I'm asking $350 for the Fuel (plus shipping), or I'd consider some sort of trade for a free-standing home NAS/network storage system or an Intel based Mac, preferably one with an mini-display port.

If you're on a tight budget I'll also accept offers for the Fuel without some of the add-ons.

_________________
***********************************************************************
Welcome to ARMLand - 0/0x0d00
running...(sherwood-root 0607201829)
* InfiniteReality/Reality Software, IRIX 6.5 Release *
***********************************************************************

antagonizt
Who joined Aug. 24, 2012, 8:52 a.m.
and authored 10 notes

Wrote the following at Nov. 12, 2012, 12:40 p.m...

PM sent, I've got a promise smartstor ns4300n with 4tb that I'd consider trading

_________________
:Indy:

bitcpy
Who joined Dec. 30, 2012, 8:48 a.m.
and authored 73 notes

Wrote the following at Jan. 10, 2013, 9:09 a.m...

I tried to PM but it looks like message is stuck in "outbox".. Is the Fuel still available?

I am interested in it.

vishnu
Who joined March 18, 2007, 2:25 p.m.
and authored 826 notes

Wrote the following at Jan. 10, 2013, 9:18 a.m...

bitcpy wrote:

...it looks like message is stuck in "outbox"..

That's a phpbb "feature," PM's stay in your outbox until the recipient reads them. That way you can edit them or even delete them ("Unsend! Unsend!") should you so choose...

bitcpy
Who joined Dec. 30, 2012, 8:48 a.m.
and authored 73 notes

Wrote the following at Jan. 10, 2013, 9:48 a.m...

Very cool feature!!! Thank you very much for the tip.

Hardware For Sale/Trade

FS/T: 600MHz Fuel, V10, 3GB, 36 and 300GB HDs, DDS4