Getting Started, Documentation, Tips & Tricks

Did my Fuel gfx go tits up?

s0ke
Donor
From TX
Who joined Feb. 24, 2003, 8:27 a.m.

Wrote the following at Feb. 21, 2016, 12:02 p.m...

So my Fuel has been chugging along nicely for that last few years. Minus the machine not keeping the date when its unplugged. A minor issue and I have been meaning to replace the dallas chip to fix that. However today I have no graphics on the machine. It boots up fine and I can ssh into, but zero shows up on the screen. I connected a serial cable to see the output:

Code: Select all


   IP35 PROM SGI Version 6.210  built 02:33:51 PM Aug 26, 2004
   

   Running in DDR mode
   

   *** Skipping diags as requested by kernel
   

   *** Diag level set to None (2)
   

   Testing/Initializing memory ...............             DONE
   

   Copying PROM code to memory ...............             DONE
   

   Discovering local IO ......................             DONE
   

   Discovering NUMAlink connectivity .........
   

   Local hub NUMAlink is down.
   

   *** Local network link down
   

   DONE
   

   Found 1 objects (1 hubs, 0 routers) in 30358 usec
   

   Waiting for peers to complete discovery....             DONE
   

   No other nodes present; becoming global master
   

   Global master is /hw/rack/001/bay/01
   

   Intializing any CPUless nodes..............             DONE
   

   Checking partitioning information .........             DONE
   

   No other nodes present; becoming partition master
   

   Loading BASEIO prom .......................             DONE
   

   

   BASEIO PROM Monitor SGI Version 6.210  built 02:30:38 PM Aug 26, 2004 (BE64)
   

   1 CPUs on 1 nodes found.
   

   Automatic update of PROM environment disabled
   

   Installing PROM Device drivers ............
   

   Base I/O Ethernet set to /dev/ethernet/ef0
   

   Installing Graphics Console...
   

   graphics install: searching for pipe 0
   

   

   Walking SCSI Adapter 0, (pci id 1)
   

   1+ Device Vendor Product: FUJITSU MAM3367MC
   

   2- 3- 4- 5- 6- 7- 8- 9- 10- 11- 12- 13- 14- 15- = 1 device(s)
   

   

   

   Walking SCSI Adapter 1, (pci id 1)
   

   1- 2- 3- 4- 5- 6+ Device Vendor Product: TOSHIBA DVD-ROM SD-M1711
   

   7- 8- 9- 10- 11- 12- 13- 14- 15- = 1 device(s)
   

   

   Initializing PROM Device drivers ..........             DONE
   

   odsy: frame buffer/fullscreen accum config causes oversubscription of sdram.
   

   odsy: frame buffer/fullscreen accum config causes oversubscription of sdram.

I came across another reference to this in forum post: viewtopic.php?t=16725016 . Down at the very bottom there was a link to another page that looked like a vpro replacement was needed.

Is there anything else I can look at? Or has my gfx board been done in.

Thanks

Redmenace